Ukazovatel spotreby MAZDA 3 2005 BK / 12Z / 2

[okbsukhoi]

• Odpoveď s citáciou

Zdravim, kupil som ojazdenu Mazdu 3 rocnik 2005. Predtym som mal moznost odskusat podobny typ ale 2004 na ktorej sa dalo navolit ukazanie spotreby. Na tejto 2005tke to vsak nejde mam tam tlacitko CLOCK a hned vedla SET. Viem ze ak by bolo vedla CLOCK INFO tak by to malo ist ale nasiel som na nete

http://www.ozmazdaclub.com/forums/3-323 ... ation.html

Tu je strucny vypis

How do I do it?

Method 1:
1) Get in, close door.
2) Insert key - DON'T TURN.
3) Hold down the 'FM1/2' or 'AM/FM' button together with the CD button. Keep them held down.
4) Turn key to ACC. Display reads 'Hello' immediately followed by 'DIS ON' (Driver Information System - On).
You might also find success turning the engine on at this stage.
5) Press the 'SET' key for at least 5 seconds. You should hear a beep.
6) Turn engine off, then back to ACC (or turn engine back on)
7) Press 'SET' again to cycle through the functions. Press 'CLOCK' to return to the clock. Press 'SET' again for the fuel trip computer.
To reset the meter, just hold down the 'SET' button on whichever mode you want reset.

Method 2:
1) Before starting the engine, keep the 'CD' and 'FM1/2' buttons pressed.
2) Start the engine.
3) After 5 seconds, you should see 'DIS ON'
4) Stop the engine.
5) Start the engine again.
6) Now, you should have your fuel computer activated.
7) Press 'SET' again to cycle through the functions. Press 'CLOCK' to return to the clock. Press 'SET' again for the fuel trip computer.
To reset the meter, just hold down the 'SET' button on whichever mode you want reset.
(This has been working in the US, has worked for some here).

Method 3: (Thanks ZOOM'N23) - Official Mazda Instructions, apparently!
1) To turn the trip computer on...
2) Start the car
3) Turn on the stereo - while the stereo is on, press the 'FM1/2' button at the same time as the 'CD' button for about 5 seconds.
4) You should then get a message saying 'DIS ON'
5) At that point, turn off the car and turn it back on to see if the trip computer has actually been activated.

Method 4: if all else fails...
A few of the guys in the US have had some luck with pressing the 'SET' button on the stereo and the 'VOLUME +' button on the steering wheel with the ignition in the 'ON' position.
(It was found that pressing the 'AM' button and 'MEDIA' buttons with the ignition on it displays 'DIS OFF', but this did not swich the trip meter off).
No guarantees this'll work at all...

Please be patient. Sometimes it takes a few goes to get it to work.
But on some, it doesn't work at all. Seems to be dependant on the Head Unit you have.
And this is why Mazda doesn't offer it as an official option.
Hope one of these solutions works for you. I will update methods and info as more comes to hand.
Good luck!

Other HU options: (Thanks to SilverSP & Jason):
LCD Test: PWR + Seek Up
Button Test: PWR + Clock
Speaker Test: PWR + Text (Right Knob)
Firmware: Audio Cont + 1
Antenna On: PWR + AM
Radio Signal: PWR + 2
Screen contrast: Audio Cont (Left Knob) + Tune-audio-M disp button (Right knob).
Hold them until it beeps and the screen will show contrast 9.
Turn the Audio Cont (Left knob) to adjust the screen contrast up (to a max of 15) or down (to a minimum of 1).

No Idea what the following does:
PWR + Seek Down
PWR + 5
PWR + 6


No ja som sa pokusal kazdy zo sposobov ale bezuspesne mate niekto skusenosit a podarilo sa vam to?
Mozno som robil nieco zle a mozno to na tejto verzii nefunguje, poprosil by som o radu pripadne vasu skusenost.
Dakujem dopredu.